Hi guys, I wish you a happy New Year!
This is my first try to move a build from betaflight to dRonin.
The FC is a SPF3 EVO the ESC are KISS 32A and the receiver is a SpekSat.
In the Vehicle Setup Wizard I choosed DSM, DSHOT600 and QUADX.
The wizard assumed the receiver is attached to UART2 so I did an additional reboot after changing it to UART3. Not much of a problem.
The main issue is that the motors do not spin, neither during the setup procedure nor later.
To make sure the hardware is working I flashed it back to betaflight. The hardware works as expected. Also I reset the flash data to the defaults to start over again. No success.
I guess it is because the KISS ESC need a valid input signal as soon as powered up. If there is no signal they shut down for safety reasons and need a power cycle to come back to life again.
So what can I do?
Any help is much appreciated!