Oplink setup CC3D Revo

This site is best viewed in a modern browser with JavaScript enabled.

Oplink setup CC3D Revo

MorneK

Can any body help with setting up a oplink on the CC3D Revo flight controller on Dronin inconceivable can not get it to work .

Mmelvis

Which type of CC3D Revo do you have? Can you post some more detailed information about the controller or the error message you are getting. Posting a picture of the controller would also be helpful.

MorneK

Hi there's no error code the oplink does not want to talk to the flight controller i have flashed the flight controller back to Dronin wired and did a Rfm bind and it talk to the flight controller it all works fine on wired saved all the settings and flashed inconceivable back on to the oplink and flight controller and loaded the settings from wired but still does not want to talk to the flight controller all the settings is the same as the settings on wired but still does not work the blue light on the ground stations does not flash the flight controller is a Cc3d Revolution i got it from bangood 10 DOF STM32F4 Flight Controller

yds

I believe with dRonin Inconceivable you may also need to flash new fw onto the OpLink for them to talk to each other.. @mlyle reworked a lot of that code before dRonin Inconceivable came out.. and the ground station OpLink also needs matching fw.

MorneK

Hi the flight controller and the oplink is flashed with Dronin inconceivable when you update to a later version you get an option to safe the settings and it can be loaded after you flash with the updated soft wear so the settings get saved as it was on the previous version.

jimzengel

Update the latest version to save the settings and load it.
2048

carolynperry

update the new version https://get-vidmateapp.com https://get-mobdroapk.com